Pinout diagram for 1.7 SDI engine control unit

Hello everyone,

Today, I installed a GRA steering column lever in my VW Polo 1.7 SDI Variant (engine code: AKW). Unfortunately, I was unable to connect it because this car doesn't have a free connector for it from the factory.

Now, I have a question: Does anyone know the pinout for the motor controller?
I could directly wire the lever to the control unit.


Here are the detailed specifications for the control unit:
VAG Number: 038 906 013J
1.7L R4EDC G20SG 1826


I would be extremely GRATEFUL for help.

Regards,

Rasmus.

Does anyone have the pinout for this?

PLEASE PLEASE HELP ME!

Complaining doesn't help.

Do you have a picture of the part?
I _suspect_ that the layout is the same as it was for the "same-age" TDIs.

Okay, so if the part has the two-piece connector, I would look up the pinout for TDIs with two-piece connectors. If it's the old, one-piece connector, then I would refer to the pinout for that.

This portal contains all sorts of information.
http://volkswagen.msk.ru/

m;

It's a 2-part plug. Thank you for the address, but I'm having trouble navigating the website. When I look at the TDIs, there are many different wiring diagrams.
I'm not really making any progress.