BMR startet nicht nach Tausch Drehzahlgeber (G28)

Go to page: Previous 1, 2

New Topic Reply 🔗 ⭐ 🖨 Dieselschrauber - Index » Diesel Engine Technology

View previous topic :: View next topic

Author

Message

dieselschrauber
Administrator

Joined: 04/12/2002
Posts: 18113
Karma: +800 / -0

Location: St.Gallen
2018 Volkswagen T6 Consumption

29-04-2025, 20:45 Subject:

Quote

phgraf wrote:

The problem was with the cable. A wire was damaged approximately 30cm after the bend. Sure, here's the translation:

"I only replaced the segment."

What a waste of time, taking out the transmissions for absolutely no reason.

Thank you for the feedback!

Dipl.-Ing. (FH) Rainer Kaufmann - Original VCDS mit KPower, KDataScope und Dieselschrauber Support

Translated on 03-07-2026, 15:19.

Profile PM WWW Garage

New Topic Reply 🔗 ⭐ 🖨 Dieselschrauber - Index » Diesel Engine Technology

View previous topic :: View next topic

Go to page: Previous 1, 2

Topic		Forum
Similar articles and topics
	Document: V6 TDI engine won't start on a downhill slope	Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
	Document: Audi A4, Engine not starting	Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
	Doku A6 4B, Standheizung startet nicht über Funkfernbed.	Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
	A6 AEL: Won't Start After ESP Replacement	Diesel Engine Technology
	Engine (SDI) Won't Start After Tuning!	Diesel Engine Technology
	VW Touareg: Won't Start After Water Pump Failure?	Diesel Engine Technology
	AFB Motor startet nicht mehr nach Leckölleitung tausch	Diesel Engine Technology

You cannot post new topics in this forum.

BMR startet nicht nach Tausch Drehzahlgeber (G28) | Posts 16+