Polo 9N: Vibration Problems & Solutions (Solution)

Author

Message

Michael II
Profi-Schrauber

Joined: 04/12/2002
Posts: 1132
Karma: +3 / -0

Location: Stuttgart

Support

05-09-2004, 11:24 Subject: Polo 9N: Vibration Problems & Solutions	Quote

Strong vibrations in the gas, clutch, and brake pedals. Cause: Incorrect installation, intake manifold installed incorrectly. Solution: There must be no contact whatsoever between the air filter and the main brake cylinder of the surge tank. Tschüss Michael II Translated on 06-10-2026, 20:04.

Ratings - Polo 9N: Vibration Problems & Solutions

Average rating: 4.00 - worst rating: 4 - best rating: 4 - number of ratings: 1 - View ratings

You are not authorized to rate this topic. Danke sagen

Topic		Forum
Similar articles and topics
	Documentary about vibrations starting at approximately 12...	Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
	Documentary about unusual engine noises and vibrations	Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
	Doku Golf 1J, Vibrations and Rumble Noises with 4Motion	Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
	Vibrations	On-Board Diagnostics (OBD)
	Idle vibration on 2.0 TDI 4V engine with Siemens PPD 1.5	Diesel Engine Technology
	A4 TDI Quattro Vibration at 1500 RPM	Diesel Engine Technology
	Engine Vibration After Head Replacement	Diesel Engine Technology

You cannot post new topics in this forum.