VCDS and OBD diagnostic device in the On-Board Diagnostics Shop
Wrenchers and tuners: diesel, petrol, OBD/VCDS. Repair, maintenance, diagnostics - help that's proven on the car.

Vintage Radios: Share Too Much?

 
New Topic Reply 🔗 ⭐ 🖨 Dieselschrauber - Index » On-Board Diagnostics (OBD)
Author Message
dieselmartin
Profi-Schrauber
Profi-Schrauber
Avatar-dieselmartin

Joined: 03/13/2003
Posts: 10121
Karma: +29 / -0   Thank you, like it!
Location: in der Werkstatt
2007 Volkswagen Passat
Premium Support

Post15-08-2012, 10:00    Subject: Vintage Radios: Share Too Much? Quote

Hi.

Can an RCD500 be operated "with only 12V"?
Or does it absolutely need a CAN gateway?

Is an A2DP hands-free system, such as the first Low model that supported it, the 1K0..730, compatible with a 3C0 907 530 C?

Except for a hands-free system with A2DP capability, I have all the other stuff left over icon_smile.gif.

m;
Transparency, Teamwork
... there was another T.

I don't know what the f*ck it was.


Translated on 31-10-2026, 17:53.
Back to top Profile PM Garage
ICeYmx



Joined: 10/26/2010
Posts: 22
Karma: +3 / -0   Thank you, like it!
Location: Vogtland

Registered VCDS User

Post15-08-2012, 12:03    Subject: Vintage Radios: Share Too Much? Quote

I think your radio will turn off after 30 minutes if it only receives power. icon_confused.gif


Translated on 31-10-2026, 17:54.
Back to top Profile PM
dieselmartin
Profi-Schrauber
Profi-Schrauber
Avatar-dieselmartin

Joined: 03/13/2003
Posts: 10121
Karma: +29 / -0   Thank you, like it!
Location: in der Werkstatt
2007 Volkswagen Passat
Premium Support

Post15-08-2012, 12:38    Subject: Vintage Radios: Share Too Much? Quote

Even if it finds a CAN-GW?
The "C" is just lying around anyway.

I know, with that idea, I'm not far from Uwe's booth anymore, because I also have a BNSTG.

m;
Transparency, Teamwork
... there was another T.

I don't know what the f*ck it was.


Translated on 31-10-2026, 17:55.
Back to top Profile PM Garage
ICeYmx



Joined: 10/26/2010
Posts: 22
Karma: +3 / -0   Thank you, like it!
Location: Vogtland

Registered VCDS User

Post15-08-2012, 21:08    Subject: Vintage Radios: Share Too Much? Quote

I'm just guessing here, since I don't know for sure: You'll probably need a BNSTG (Battery, Neutral, Start, Transmission, Ground) signal to tell the radio, via the GW (Gateway) and subsequently the other CAN bus, that the ignition is on. The ignition switch can certainly be simulated with a regular switch.


Translated on 31-10-2026, 17:55.
Back to top Profile PM
dieselschrauber
Administrator
Administrator
Avatar-dieselschrauber

Joined: 04/12/2002
Posts: 18135
Karma: +804 / -0   Thank you, like it!
Location: St.Gallen
2018 Volkswagen T6 Consumption


Post16-08-2012, 14:57    Subject: Vintage Radios: Share Too Much? Quote

Hello,

Instead of using many control units, one could simply send a "ignition on" signal to the CAN bus at the radio. icon_wink.gif
It would just be a small DIY project.

Best regards, Rainer.


Translated on 31-10-2026, 17:56.
Back to top Profile PM WWW Garage
dieselmartin
Profi-Schrauber
Profi-Schrauber
Avatar-dieselmartin

Joined: 03/13/2003
Posts: 10121
Karma: +29 / -0   Thank you, like it!
Location: in der Werkstatt
2007 Volkswagen Passat
Premium Support

Post16-08-2012, 15:03    Subject: Vintage Radios: Share Too Much? Quote

With all these STGs (Standard Terminal Units), I would also have a VCDS playground... uh... a demonstrator.
Transparency, Teamwork
... there was another T.

I don't know what the f*ck it was.


Translated on 31-10-2026, 17:56.
Back to top Profile PM Garage
New Topic Reply 🔗 ⭐ 🖨 Dieselschrauber - Index » On-Board Diagnostics (OBD)
Similar articles and topics
Topic Forum
No new posts ESD for 1Z and part number 028 130 201 HX. Is it compatib... Diesel Engine Technology
No new posts DPF Loose Parts: Buy Now & Save! Diesel Engine Technology
No new posts 2.5 TDI: Parts found in the oil pan Diesel Engine Technology
No new posts Adapter cable parts for Powerbox Diesel Engine Technology
Jump to:  
You cannot post new topics in this forum.