I tried to change the time for CH (STG 9 -> Adjustment -> Channel 1 -> Saved Value 30), and I reduced it to 15, but nothing changed!
The light always stays on for approximately 1 minute and 30 seconds afterward!
The value "30" that was saved should actually represent "30 seconds," but it's possible that this setting can only be adjusted when the switch is physically installed. However, that's just a guess...
or you could just try using this encoding and see if it works.
It doesn't work with this encoding either!
If I install a Golf V manual transmission, will the LH system still work?
Just switching a switch, is that all it takes?
"The switch should fit without any problems... but I can't guarantee that it will work 100%, because there are too many different control units involved. But just check on eBay and see if you can find one cheaply... if it doesn't work, you can just put the old one back in and sell it again for the same price."