VCDS and OBD diagnostic device in the On-Board Diagnostics Shop
Diesel technology, engine technology, vehicle diagnostics, repair & maintenance.

CR generell - Raildruck zu hoch | Posts 16+

 
Go to page: Previous  1, 2
New Topic Reply 🔗 🖨 Dieselschrauber - Index » Diesel Engine Technology
Author Message
vwSchrauber
Profi-Schrauber
Profi-Schrauber


Joined: 09/18/2008
Posts: 1262
Karma: +42 / -0   Thank you, like it!


CAN Support

Post09-03-2012, 13:49    Subject: Quote

Does the F9Q have a Bosch system?

In the case of Densopump models (PSA 2.2HDi, John Deere, etc.), this issue occurs much more frequently, and often leads to strange problems, driving workshops to the brink of madness icon_lol.gif.
selber schrauben - statt Werkstattpfusch
Back to top Profile PM
vagtuning
Guest




 


Free account, no CAN development support

Post09-03-2012, 13:59    Subject: Quote

Yes, it's a Bosch system, with Bosch injectors and a...
Old Bosch CP3 HDP with mechanical pre-pump.
attached to the HDP, without a fuel pump and a...
Manual pump on the diesel filter for bleeding.
Back to top
New Topic Reply 🔗 🖨 Dieselschrauber - Index » Diesel Engine Technology
Go to page: Previous  1, 2
Similar articles and topics
Topic Forum
No new posts Raildruck zu niedrig, 3.0 CR-TDI General Tips
No new posts P3366 - Systemdruck Gas: zu hoch Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
No new posts P2185 - Kühlmittel Temperatursensor, zu hoch Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
No new posts VW T5 CFCA Rail pressure too high during acceleration Diesel Engine Technology
No new posts Neigt PD generell zu einem Startwölkchen ? Diesel Engine Technology
No new posts Raildruck Upload
No new posts Rail pressure too low. - Is the high-pressure pump faulty? Gasoline Engine Technology
Jump to:  
You cannot post new topics in this forum.