VP37 Pump Connector Pinout: Wiring Diagram

Hello,
I've developed a 10-cent tuning method that incorporates a delay.
I am familiar with the connection for the eight-pin connector.
Resistance in cables 2 and 3, and turn-on delay in cables 4 and 5 (corresponding to positive and negative).

I need the information for the 10-pin connector.
-I understand that the resistance will appear again in parts 2 and 3.
Where is the positive and negative terminal on a 10-pin connector?
Does anyone have a wiring diagram?

You have mail .

Best regards, Rudi.

@ rudi

No, I haven't received any messages from you.
Does anyone know where the positive and negative terminals are located on the 10-pin connector?

Hmm...
I emailed it to the address you provided ([email protected]), and I haven't received anything back yet.

Pin 1 signal, rule slider position sensor, G149, reference coil.
Pin 2 'Power Supply' potentiometer G149.
Pin 3 signal, control slide, G149 measurement coil.
Pin 4: Sensor ground.
Pin 5 supply, N146 (quantity control).
Pin 6 controls N146 (flow control valve).
Pin 7: Fuel temperature signal, sensor G81.
Pin 8: Fuel shut-off valve control (N109).
Pin 9 controls N108 (fuel injection start valve).
Pin 10 supplies voltage to N108 (fuel injection start valve).


Best regards, Rudi.

Hello,
Do you also have the data for comparison for the eight-pin connector?
That would be really great, because then all my problems would be solved.

Hi,
Here's the number 8:

Pin 1 signal, rule slider position sensor, G149, reference coil.
Pin 2 'Power Supply' potentiometer G149.
Pin 3 Signal, Control Slider Path Sensor, G149 Measurement Coil.
Pin 4: Sensor ground.
Pin 5 supply, N146 (quantity control).
Pin 6 controls N146 (flow control valve).
Pin 7: Fuel temperature signal, sensor G81.
Pin 8 not used.


Best regards, Rudi.