Audi 8E2 Wiper Problems: Fix Sticking Issues (Solution)

Author

Message

Michael II
Profi-Schrauber

Joined: 04/12/2002
Posts: 1132
Karma: +3 / -0

Location: Stuttgart

Support

01-10-2003, 9:40 Subject: Audi 8E2 Wiper Problems: Fix Sticking Issues	Quote

The wipers intermittently stop working, while the wiper motor continues to run. Cause: Crank arm for wiper linkage, loose on the conical drive shaft of the wiper motor. Solution: If the crankshaft becomes loose, always replace the wiper motor along with the crank arm. Tschüss Michael II Translated on 31-08-2026, 16:05.

Ratings - Audi 8E2 Wiper Problems: Fix Sticking Issues

Average rating: 0.00 - worst rating: 0 - best rating: 0 - number of ratings: 0 - View ratings

You are not authorized to rate this topic. Danke sagen

Topic		Forum
Similar articles and topics
	A4 8D Document: Timer Stuck - Troubleshooting	Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
	ABS Light On: VW Transporter T4 Troubleshooting	Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
	Audi A3 8L, Golf 4 etc. - Turn signal relay is malfunctio...	Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
	Electric: G3 Wiper Blades Remain Different	Diesel Engine Technology
	AVB: Intermittent Freezing Issues	Diesel Engine Technology
	My 110hp Audi TDI with the AFN engine is misfiring when i...	Diesel Engine Technology
	Audi Q7 Batterie sporadisch entladen	Electrical Systems, Vehicle Electronics, Multimedia

You cannot post new topics in this forum.