Yesterday, I installed the new nozzle with the smaller hole in my BLB (presumably referring to a 3D printer hotend).
The engine immediately ran more smoothly, but it had absolutely no power.
'It was like the emergency program, except the engine control light didn't come on.'
Normally, the engine should still run even with the EGR system completely disconnected, right?
I took it out again, and now it's shaking/vibrating again.
Does anyone have any advice? Or do I need to make any further adjustments?
NA,Gehörlose wie ich können auch Schrauben! Ihr HÖRT ich FÜHLE! T3 TD EX-JX Jetzt 1Z mit 122PS und Renaultgetriebe Golf II TD Bj 84 512Tkm Passi 35I 1Z 468Tkm--> Seat Toledo AHF-- Toledo ARL 477Tkm mit Spritspartuning 99er T4 Syncro-Cross 100800km grad eingefahren