VCDS and OBD diagnostic device in the On-Board Diagnostics Shop
Diesel, Engine Technology and Vehicle Technology. Repair, Maintenance and Diagnostics (OBD).

Dieselmief und Nachrüstkat | Posts 32+

 
Go to page: Previous  1, 2, 3
New Topic Reply 🔗 🖨 Dieselschrauber - Index » Diesel Engine Technology
Author Message
eike
Guest




 


Free account, no CAN development support

Post21-01-2003, 18:12    Subject: Quote


So, I drive in the highest possible gear, typical for a TDI, at the lowest possible RPM – between 1000 and 1500 RPM – and let it pull when needed.

Because I already pay my environmental tax every year in advance through taxes icon_twisted.gif.

Hi Ulf,

In driving school, you still learn today that driving at excessively low RPMs is not good for the engine because it doesn't develop enough oil pressure.
Do you know at what speed the nominal pressure is reached?

Regards,

Eike.


Translated on 10-08-2026, 4:13.
Back to top
ulf
Profi-Schrauber
Profi-Schrauber


Joined: 04/13/2002
Posts: 11058
Karma: +18 / -0   Thank you, like it!
Location: Saarland
2023 MG ZS
Premium Support

Post21-01-2003, 18:41    Subject: Quote

eike wrote:

Do you know at what speed the nominal pressure is reached?



Hi Eike,

What is the nominal pressure for the TDI or AFN engine?

For example, the idle pressure is either 7 bar at cold start (above which the limiter valve opens) or approximately 1 bar with a warm engine?
Between those points, everything is possible during operation icon_eek.gif.

The values were read from my Conrad multimeter.

But I won't let it fully extend if the oil pressure is below 2 bar icon_wink.gif.
Gruß Ulf
_________

MG4 Electric


Translated on 10-08-2026, 4:14.
Back to top Profile PM Garage
New Topic Reply 🔗 🖨 Dieselschrauber - Index » Diesel Engine Technology
Go to page: Previous  1, 2, 3
Similar articles and topics
Topic Forum
No new posts Cat Tax Savings: Retrofit Your Car Now! Diesel Engine Technology
Jump to:  
You cannot post new topics in this forum.