Starke Vibrationen beim Beschleunigen (Solution) | Posts 32+

So, replacing the hydraulic mount isn't really a problem.
The gearbox bearings were impressive.
To describe it in more detail:
The bearings where the drive shafts are attached will be replaced. He said there's a bearing kit for that.

That would be the bearing for the shaft with the flange. If it's constructed like the one in my gearbox, it's quite simple. I understood "gearbox mounting" differently.
hg
Herbert.

Yes, exactly that storage method. Sorry, because I expressed myself incorrectly.
He should be finished by tomorrow. I'm curious to see if that's all there is to it...
I will report.

Okay, so the bearings have been replaced and the brake light switch problem has been fixed, but the vibrations are still there.
The engine mount was also replaced.
The workshop's suspicion is due to the new drive shafts.
Apparently, the warehouses are not running properly .

I can hardly imagine it...

Similarly, a solution for this was found yesterday.

Both brand new drive shafts had defective inner bearings. Both showed damage on each bearing seat, which was likely caused during the manufacturing process.

So, you've swapped out old, defective drive shafts for new, defective ones.

Pay more attention to the quality of spare parts in the future.

Nevertheless, thank you for the feedback .