AVF Idle Speed Control - Cylinder 3

Good evening.

Either the search function isn't working, or I'm too stupid to use it... anyway, I always get an error message.
I would actually just like to ask if, based on your experiences, I should be concerned about the slow pressure drop in the 3rd cylinder. The value remains almost constantly between +0.30 and +0.40. Apparently, the 2nd cylinder is compensating for this, and it remains at the same value but in the negative range.
Should I get the valve timing and PDE checked, or should I just leave it alone as long as the engine is running?

Leave it like that. That's perfectly fine.

Ok. Thank you.

I have a question about air mass and boost pressure overshoots. Last night, I logged data from measurement blocks 3, 6, and 11. The measurements were taken under full load in 4th gear, followed by a brief period in 5th gear.
Are the values okay?

Please let me know if the logs are incorrect! Or why doesn't anyone want to respond...?

Perhaps because it's been asked a thousand times already, and there's more than enough information to be found using the search function and in the specialized articles?