Hello everyone,
I hope you can support me.
Der Golf 6 meiner Schwester war im Notlauf. Darauf hin habe ich den Fehlerspeicher ausgelesen und gelöscht. Log, below.
Since then, the car has been running without any problems. However, I would have expected a high soot value in the error memory, which is not the case. The car is almost exclusively driven on short trips and often doesn't get properly warm. That's exactly what you shouldn't do with a diesel engine, I know

.
I wanted to try a regeneration process while the system was idle, but it's being interrupted with the following error:
"Interrupted (security error) | Error".
Can you identify the cause of the error in the log? The DPF shouldn't be clogged. Should I just continue driving?
Thank you very much and best regards.
Chris.
Quote: |
8194 - Diesel particulate filter.
P2458 00 [237] - Regeneration time.
Warning light ON - confirmed - checked since last reset.
Environmental conditions:
Error status: 00000001
Error priority: 2
Error frequency: 1.
Mileage: 122,869 km
Date: 2023.03.31
Time: 18:54:24
Motor speed: 2362.00 rpm.
Normalized load value: 53.3%
Vehicle speed: 92 km/h
Coolant temperature: 80 °C.
Intake air temperature: 15 °C
Atmospheric pressure: 950 millibars.
Voltage at terminal 30: 14,700 V.
Lost learning counter via OBD: 40.
Particle filter regeneration time counter: 12600.10 s.
Particle filter: Kilometers since last regeneration: 394428 km.
Particulate filter: Soot mass measured: -4.25 g.
Particle filter: Calculated soot mass: 6.36 g.
Particle filter differential pressure dynamic offset: 5 hPa |