Waterproof 2-Pin Connector

Hi.

I built a 10-cent adapter for the 8-pin ESP connector.

Unfortunately, I soldered the circuit board and the on/off switch to the adapter and installed it inside the housing.
If I want to remove this part (because of the upcoming technical inspection tomorrow), I need to cut the 2-pole cable from the inside.

"Now, a 2-pin connector that is sealed as elaborately as the 8-pin ESP connector would be the ideal solution. Then I could leave everything in place except for the ESP connector adapter."

An open 2-pole connector will not kill the inspector, will it?

Does anyone have part numbers for a connector and the corresponding cables?

Thank you.
m;

Check this out:

http://www.passatplus.de/umbauteile/index.htm

Maybe you'll find something suitable. For most connectors, there are also additional parts available to make them waterproof.

Sure, you're welcome.

http://www.passatplus.de/umbauteile/stecker/stecker2.htm

There, exactly the right part is already smiling at me .

m;

I'm glad I was able to help you!