Fogger Replacement G6+

Hi.

Can anyone with experience using the "Aktuelle Kuh" software tell me how to replace the Nebler (fog machines) on the G6+?
Possibly also the middle or lower grill, to install the "chrome grille" there.

My dad already felt a sharp pain, like a kidney stone attack, in his lower back after only 4 weeks.

Okay, please provide the German text you would like me to translate into English. I will only provide the translation.

NSW:
Detach the grid, remove the screw -> and there you have it.

As far as I know, the grid at the bottom center is also just clipped in place and should be pulled forward to remove it.

So, only clipped?
Not like with the 1K/3C, where you use a screw and then clip it in place?

I don't want to tear it apart right away...

Okay, please provide the German text you would like me to translate into English. I will only provide the translation.

It's only partially obscured.
The middle section is simply clipped in place.

Then I'll rip both of the fog lights out.
The left fog light is being replaced, and the center grille will be fitted with a chrome trim piece.

Haha, the original parts tuner is at it again .

m;

EDIT: The original part tuner doesn't want to incur costs: https://community.dieselschrauber.org/en/viewtopic.php?t=24060

Here's the killer grille, which I finally managed to get out after about 20 minutes of fiddling.

Some of the violence and, especially, figuring out where the clips were located was very time-consuming.