| Author |
Message |
captaindickei Blaumann

Joined: 04/02/2007 Posts: 53 Karma: +1 / -1
Free account, no CAN development support
|
22-02-2011, 18:34 Subject: ASZ Pressure Hoses for Intercooler |
Quote |
|
Hey,
"On a Golf IV with an ASZ engine, the intercooler was leaking, and we have a new one here (quite a bit of oil came out)."
The problem is:
I just checked and cleaned the two pressure hoses. I have a feeling they are nearing the end of their lifespan and probably aren't completely airtight anymore. It's also difficult to test with a compressor.
At "Freundlicher," the two pressure hoses together cost approximately 75 euros. That's simply too expensive for just two small pieces of hose.
Have you had any experience with these pressure hoses? Do these typically leak, or is it enough to just replace the four seals?
I have attached an image of the two parts.
Best regards and thank you.
| Description: |
| Druckschläuche und Kupplungen, Ladeluftsystem ASZ Motor. |
|
| File size: |
1.72 MB |
| Viewed: |
2227 times |

|
|
|
| Back to top |
Profile PM |
 |
TDI-GTI-4-Motion Profi-Schrauber


Joined: 02/22/2009 Posts: 3872 Karma: +127 / -0
2002 Volkswagen Golf  Premium Support
|
22-02-2011, 18:47 Subject: ASZ Pressure Hoses for Intercooler |
Quote |
|
Ah, that lovely, permanently leaky connector system. That's already garbage, even when it's new.
Replace the seals and just accept that it will always be slightly leaky.
Alternative: Attach.
MfG. Michael
VW Golf IV TDI GTI 4-Motion Bj.2002 MKB/GKB: ARL/FEK
VW T4 Pritsche TDI Bj.1999 MKB/GKB: AXG/AFK (Selfmade) |
|
| Back to top |
Profile PM Garage |
 |
captaindickei Blaumann

Joined: 04/02/2007 Posts: 53 Karma: +1 / -1
Free account, no CAN development support
|
22-02-2011, 18:48 Subject: ASZ Pressure Hoses for Intercooler |
Quote |
|
Thank you for the reply; (or Thank you for your answer;).
I haven't seen a single TDI yet where everything is completely dry...
Then I can leave the seals in place and reassemble it like that, right?
|
|
| Back to top |
Profile PM |
 |
TDI-GTI-4-Motion Profi-Schrauber


Joined: 02/22/2009 Posts: 3872 Karma: +127 / -0
2002 Volkswagen Golf  Premium Support
|
22-02-2011, 18:51 Subject: ASZ Pressure Hoses for Intercooler |
Quote |
|
captaindickei wrote: | | then I can leave the seals in place and reassemble it like that, right? | It should definitely be a little better. It doesn't cost the world, and I would go along with it if it's already falling apart. 
MfG. Michael
VW Golf IV TDI GTI 4-Motion Bj.2002 MKB/GKB: ARL/FEK
VW T4 Pritsche TDI Bj.1999 MKB/GKB: AXG/AFK (Selfmade) |
|
| Back to top |
Profile PM Garage |
 |
captaindickei Blaumann

Joined: 04/02/2007 Posts: 53 Karma: +1 / -1
Free account, no CAN development support
|
22-02-2011, 19:49 Subject: ASZ Pressure Hoses for Intercooler |
Quote |
|
Okay, let's see where I can quickly get those tomorrow.
Normally, a little bit of boost pressure should always escape, right?
|
|
| Back to top |
Profile PM |
 |
TDI-GTI-4-Motion Profi-Schrauber


Joined: 02/22/2009 Posts: 3872 Karma: +127 / -0
2002 Volkswagen Golf  Premium Support
|
22-02-2011, 20:52 Subject: ASZ Pressure Hoses for Intercooler |
Quote |
|
captaindickei wrote: | | Normally, shouldn't there always be a little bit of boost pressure escaping there? | Minimal, yes.
MfG. Michael
VW Golf IV TDI GTI 4-Motion Bj.2002 MKB/GKB: ARL/FEK
VW T4 Pritsche TDI Bj.1999 MKB/GKB: AXG/AFK (Selfmade) |
|
| Back to top |
Profile PM Garage |
 |
captaindickei Blaumann

Joined: 04/02/2007 Posts: 53 Karma: +1 / -1
Free account, no CAN development support
|
22-02-2011, 20:53 Subject: ASZ Pressure Hoses for Intercooler |
Quote |
|
Is there maybe some kind of filler or something to make it seal?
He's constantly messing with me.
|
|
| Back to top |
Profile PM |
 |
TDI-GTI-4-Motion Profi-Schrauber


Joined: 02/22/2009 Posts: 3872 Karma: +127 / -0
2002 Volkswagen Golf  Premium Support
|
22-02-2011, 20:57 Subject: ASZ Pressure Hoses for Intercooler |
Quote |
|
captaindickei wrote: | | Maybe there's some kind of sealant or something like that to make it airtight... | Forget about sealant; the minimal movement between the two parts will immediately make it leak again.
If it really sticks together and becomes impossible to separate.
MfG. Michael
VW Golf IV TDI GTI 4-Motion Bj.2002 MKB/GKB: ARL/FEK
VW T4 Pritsche TDI Bj.1999 MKB/GKB: AXG/AFK (Selfmade) |
|
| Back to top |
Profile PM Garage |
 |
captaindickei Blaumann

Joined: 04/02/2007 Posts: 53 Karma: +1 / -1
Free account, no CAN development support
|
22-02-2011, 20:58 Subject: ASZ Pressure Hoses for Intercooler |
Quote |
|
Hmm, using glue is also a bit unprofessional...
Then I'll have to buy 4 seals from VW, even though they cost over 3 euros each.
|
|
| Back to top |
Profile PM |
 |
TDI-GTI-4-Motion Profi-Schrauber


Joined: 02/22/2009 Posts: 3872 Karma: +127 / -0
2002 Volkswagen Golf  Premium Support
|
22-02-2011, 21:03 Subject: ASZ Pressure Hoses for Intercooler |
Quote |
|
captaindickei wrote: | | hmm, gluing things is also a bit unprofessional... | The whole system is unprofessional! 
MfG. Michael
VW Golf IV TDI GTI 4-Motion Bj.2002 MKB/GKB: ARL/FEK
VW T4 Pritsche TDI Bj.1999 MKB/GKB: AXG/AFK (Selfmade) |
|
| Back to top |
Profile PM Garage |
 |