VCDS and OBD diagnostic device in the On-Board Diagnostics Shop
Diesel, Engine Technology and Vehicle Technology. Repair, Maintenance and Diagnostics (OBD).

Engine Power & RPM: Explained Simply

 
New Topic Reply 🔗 🖨 Dieselschrauber - Index » Diesel Engine Technology
Author Message
Holger
Guest




 


Free account, no CAN development support

Post20-06-2002, 20:06    Subject: Engine Power & RPM: Explained Simply Quote

To all professionals,

I have two questions.

My diesel TDI with 115 horsepower, engine code AJM, 5-speed manual transmission.
is very weak at higher speeds.
That means it comes on based on the climate control system (not the speedometer).
at 185 km/h on a straight road with no wind.
That's all there is. Suit and tie, from top to bottom.
He runs powerfully.
I know that a diesel engine doesn't have much power at higher RPMs.
But I can't even reach 4200 RPM.
The LMM is clean (visually). The wires are definitely okay.
blank. Is this normal, or what could be the cause?


What is the deadline for submitting the application?
Ich hab mal versucht, im 4. Walked all the way to...
rote Feld, bis fast bei 4.9000 U/min. No reaction.
Regarding throttling!

I don't want to try again, unless...
Does the automatic start-up system (ASU) cause the engine to rev up to its maximum speed?

Thank you for your help.
Best regards, Holger.


Translated on 21-08-2026, 5:18.
Back to top
D.
Guest




 


Free account, no CAN development support

Post20-06-2002, 20:57    Subject: Engine Power & RPM: Explained Simply Quote

Hello Holger!

Unfortunately, only for point 2, as I am not a professional.

During the emissions test (ASU), the inspector fully depresses the accelerator pedal (while stationary, without engaging a gear) until the engine reaches its maximum RPM limit. During this process, both the time it takes for the engine to reach its maximum RPM and the level of pollutant emissions are measured.

Best regards, D.


Translated on 21-08-2026, 5:21.
Back to top
Holger
Guest




 


Free account, no CAN development support

Post20-06-2002, 21:05    Subject: Engine Power & RPM: Explained Simply Quote

Hello D.

'I understand everything, but what I meant was...'
is when the engine does not automatically shut off.
As far as I was in the red zone, that shouldn't be possible.
'Is it not normal?' or 'Isn't it normal?'


Best regards, Holger.


Translated on 21-08-2026, 5:22.
Back to top
Uwe
Profi-Schrauber
Profi-Schrauber


Joined: 04/15/2002
Posts: 1004
Karma: +5 / -0   Thank you, like it!
Location: Westerwald

Premium Support

Post20-06-2002, 22:10    Subject: Engine Power & RPM: Explained Simply Quote

Hi Holger!

My wife drives an A4 with a 115 hp AJM engine. The top speed, according to the speedometer, is 220 km/h. If you can only reach 185 km/h, something is definitely not right (what kind of car do you have?). The most common issue seems to be the mass airflow sensor (MAF). It doesn't necessarily have to be visibly dirty to provide incorrect readings. It's relatively easy to test by driving a different car. Your workshop will likely lend you one for a test drive.

"Your engine will definitely reach its rev limit, that's for sure. Diesel engines, by their design, cannot achieve high RPMs. The electronics typically cut off at around 5,000 RPM. Comparable gasoline engines often run up to 7,000 RPM or more and can sustain those speeds for longer periods. It's important that the engine is operating under normal conditions, especially that the oil temperature should be at least 80 degrees Celsius. Then you can give it full throttle even when idling without any problems; nothing will happen."

Best regards,
Uwe


Translated on 21-08-2026, 5:24.
Back to top Profile PM
Holger
Guest




 


Free account, no CAN development support

Post21-06-2002, 7:01    Subject: Engine Power & RPM: Explained Simply Quote

Thank you all very much, especially Uwe.

I'll try that out with the LLM.

Oh yeah, I have an Audi A4 Avant.

Best regards, Holger.


Translated on 21-08-2026, 5:25.
Back to top
Michael II
Profi-Schrauber
Profi-Schrauber


Joined: 04/12/2002
Posts: 1132
Karma: +3 / -0   Thank you, like it!
Location: Stuttgart

Support

Post21-06-2002, 8:52    Subject: Engine Power & RPM: Explained Simply Quote

Hello,

It's not always the LMM that's at fault. To get a clearer picture, simply have the measurement data blocks printed out. For the AJM, they are available in the error database.
Tschüss

Michael II


Translated on 21-08-2026, 5:26.
Back to top Profile PM
Holger
Guest




 


Free account, no CAN development support

Post21-06-2002, 10:19    Subject: Engine Power & RPM: Explained Simply Quote

Sure, thanks in advance.

I'll get it checked out.

Best regards, Holger.


Translated on 21-08-2026, 5:26.
Back to top
New Topic Reply 🔗 🖨 Dieselschrauber - Index » Diesel Engine Technology
Similar articles and topics
Topic Forum
No new posts TDI V6: Documenting Engine Power Loss Issues Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
No new posts TDI Engine Problems: Low Power & Error Code 00553 Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
No new posts Idle speed and emissions test Diesel Engine Technology
No new posts AFN, Abregeldrehzahl gesunken Diesel Engine Technology
No new posts Abregeldrehzahl 1,4l PD-TDI zu hoch? Diesel Engine Technology
No new posts Chip Tuning: Speed Limiter Removal? Diesel Engine Technology
Jump to:  
You cannot post new topics in this forum.