VCDS and OBD diagnostic device in the On-Board Diagnostics Shop
Diesel, Engine Technology and Vehicle Technology. Repair, Maintenance and Diagnostics (OBD).

Motorsteuergerät an WFS anlernen | Posts 16+

 
Go to page: Previous  1, 2
New Topic Reply 🔗 🖨 Dieselschrauber - Index » On-Board Diagnostics (OBD)
Author Message
Rudi
Guest




 


Free account, no CAN development support

Post06-09-2007, 18:00    Subject: Quote

N.C. = No Contact???
Is the Ready/Busy status not being evaluated or something? So, are those two pins actually irrelevant for now? Should the device still work even without them?
If that's all there is - yes.


Translated on 07-08-2026, 3:31.
Back to top
SpaceDragon
Guest




 


Free account, no CAN development support

Post06-09-2007, 22:57    Subject: Quote

Unfortunately, it's not working. So I'm waiting for a new control unit. Thank you anyway.


Translated on 07-08-2026, 3:31.
Back to top
New Topic Reply 🔗 🖨 Dieselschrauber - Index » On-Board Diagnostics (OBD)
Go to page: Previous  1, 2
Similar articles and topics
Topic Forum
No new posts Train T90 / T 91 with VCDS Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
No new posts Wie Lenkwinkelsensor neu anlernen? Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
No new posts T5 Model 2014 Key Programming via VCDS Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
No new posts Polo 9N FSI engine control unit programming Gasoline Engine Technology
No new posts Golf 4 engine control unit programming On-Board Diagnostics (OBD)
No new posts Immobilizer: Engine Control Unit (ECU) Not Learning On-Board Diagnostics (OBD)
No new posts WFS Setup: How to Configure and Use On-Board Diagnostics (OBD)
Jump to:  
You cannot post new topics in this forum.