Ölvermehrung beim ASZ. PDEs aus u. einbauen? Fotos (Solution) | Posts 16+

11-02-2015, 18:59 Subject:

Hello,
I'm cautiously optimistic now about a more permanent fix for the issue. If it gets worse again, then it can only be the cylinder head.
However, the oil level has stabilized after driving approximately 360 kilometers. (Before that, there was a noticeable increase, even after just a few kilometers).

The error has definitely been found.
The exhaust smell, oil leaks, smoke, and ultimately the difficulty starting when the fuel level was below 1/3 of the tank, all had the same root cause and were completely resolved by sealing the positive electrode displacement (PED) units.

Thank you again to everyone who helped me troubleshoot and repair this issue.

Best regards,
Jörg

11-02-2015, 19:33 Subject:

Thank you for the feedback!

dieselschrauber · 11-02-2015, 20:39 Subject:

MWB 13 is okay, warmed up beforehand.
Zyl -0.35
Zyl2 -0.31
Zyl3 +0.31
Zyl4 +0.33
(Oil level still stable, now after approximately 600 km).
Thank you again!

That is probably the least I can still do

.
I can't increase your karma, because mine is lower

.
Best regards, Jörg.