Audi A2: Dashboard shows only range (Solution)

Author

Message

Michael II
Profi-Schrauber

Joined: 04/12/2002
Posts: 1132
Karma: +3 / -0

Location: Stuttgart

Support

01-01-2003, 17:49 Subject: Audi A2: Dashboard shows only range	Quote

The onboard computer only displays the estimated range, and it is not possible to cycle through other functions using the switch on the wiper stalk. Only VDO manufacturers with driver information systems. Cause: Incorrect adjustment performed in channel 18 of the terminal block module during manufacturing. Solution: Change the adjustment value in channel 18 of the switchboard module to XXX0X (leave the X values unchanged). Tschüss Michael II Translated on 22-09-2026, 8:13.

Ratings - Audi A2: Dashboard shows only range

Average rating: 5.00 - worst rating: 5 - best rating: 5 - number of ratings: 1 - View ratings

You are not authorized to rate this topic. Danke sagen

Topic		Forum
Similar articles and topics
	Wind Noise in Audi A2 (8Z0) 2002: Documentary	Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
	Audi A2 Noises: 8Z0 MJ 2002 Documentary	Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
	Document A2 8Z0 MJ 2002, HVAC failure	Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
	Range Webasto T70/T90	Transmission, Chassis, Body & Interior
	1Z Measurement Block 13: What Does It Show?	On-Board Diagnostics (OBD)
	Fuel Injection Timing: Diagnostic Tool Results	Diesel Engine Technology
	MFA: 3x Higher Than Average Consumption	Diesel Engine Technology

You cannot post new topics in this forum.