VCDS and OBD diagnostic device in the On-Board Diagnostics Shop
Wrenchers and tuners: diesel, petrol, OBD/VCDS. Repair, maintenance, diagnostics - help that's proven on the car.

Reset Service Light: Won't Turn Off?

 
Go to page: 1, 2  Next
New Topic Reply 🔗 ⭐ 🖨 Dieselschrauber - Index » On-Board Diagnostics (OBD)
Author Message
Marco
Guest




 


Free account, no CAN development support

Post24-04-2004, 19:46    Subject: Reset Service Light: Won't Turn Off? Quote

Hello fellow enthusiasts,

After completing all the necessary maintenance work on my A4 B5, I tried today to reset the longlife service indicator according to Bertil's instructions. I adjusted the following channels according to the instructions for a 6-cylinder TDI engine.

Channel 42 / Value: 15 (Minimum distance to next oil change).
Channel 43 / Value: 35 (Distance until next oil change).
Channel 44 / Value: 730 (Time in days)
Kanal 45 / Wert: 3 (Verw. Öl Qualität Longlife 6 Zyl. Diesel engines)

After that, a quick check of the dashboard, 'Service in 35000km' looked good, I thought, but then when I turn the ignition off and on again, the dashboard tells me 'Service in 15000km' icon_question.gif icon_question.gif icon_question.gif.
I'm probably just too dense to figure this out today. Does anyone have any ideas about what I might be doing wrong or overlooking?


Translated on 29-10-2026, 10:18.
Back to top
smith2
Guest




 


Free account, no CAN development support

Post26-04-2004, 8:12    Subject: Reset Service Light: Won't Turn Off? Quote

Hi, you also need to adjust the channel that displays the 'Service due' or 'Service not due' status.

My Skoda Octavia's registration number is 02.

cu smith2


Translated on 29-10-2026, 10:19.
Back to top
Marco
Guest




 


Free account, no CAN development support

Post26-04-2004, 8:37    Subject: Reset Service Light: Won't Turn Off? Quote

Hi Smith2,

Okay, I did that. However, Bertil's instructions also state that if '02' is entered, fixed intervals (15000 km) are automatically set. The problem is that I initially see 35000 km displayed, but then, after turning the ignition off and on again, the FIS displays 15000 km.


Translated on 29-10-2026, 10:20.
Back to top
Bertil
Profi-Schrauber
Profi-Schrauber


Joined: 04/15/2002
Posts: 5628
Karma: +108 / -0   Thank you, like it!


Premium Support

Post26-04-2004, 9:12    Subject: Reset Service Light: Won't Turn Off? Quote

Marco wrote:
Only in Bertil's instructions does it state that when channel 02 is entered, fixed intervals (15000 km) are automatically set.

First, you need to adjust Channel 2. After that, you can proceed with the LL adjustment.
Quote:
The thing is, I initially get a reading of 35,000 km -> then, after turning the ignition off and on again, the FIS displays 15,000 km.


After the LL inspection, the minimum interval is initially displayed, and it gradually increases over time to reach the target LL value. This process depends on the driving profile. However, since you haven't driven much since the service, a precise calculation hasn't been performed yet.
Gruß Bertil

Skoda 5E5 CZDA + Mini R50 W10 + VW ID.3 + Fiat Ducato 250 + 161 DX

*** Technische Anfragen per PN werden von mir nicht beantwortet! ***


Translated on 29-10-2026, 10:21.
Back to top Profile PM
Marco
Guest




 


Free account, no CAN development support

Post26-04-2004, 9:24    Subject: Reset Service Light: Won't Turn Off? Quote

Hi Bertil,

Thank you for the information! I will continue to monitor the FIS. Could you please add this point to the instructions? I think it would be very helpful.


Translated on 29-10-2026, 10:22.
Back to top
smith2
Guest




 


Free account, no CAN development support

Post26-04-2004, 9:25    Subject: Reset Service Light: Won't Turn Off? Quote

Sorry, Bertil.

You got to me first.
My answer is not related to yours.

cu smith2


Translated on 29-10-2026, 10:23.
Back to top
Marco
Guest




 


Free account, no CAN development support

Post26-04-2004, 9:43    Subject: Reset Service Light: Won't Turn Off? Quote



For vehicles with fixed intervals, completely different channels must be configured.

cu smith2

Hi Smith2,

Even I understood that! icon_wink.gif

Okay, seriously, I'm going to re-check the display again, and if it's still not showing correctly, I'll adjust it again. I adjusted channel 02 last, so maybe that's the problem. However, I did see that it displayed 35,000 km, so I'm assuming everything is correct.


Translated on 29-10-2026, 10:24.
Back to top
Bertil
Profi-Schrauber
Profi-Schrauber


Joined: 04/15/2002
Posts: 5628
Karma: +108 / -0   Thank you, like it!


Premium Support

Post26-04-2004, 11:21    Subject: Reset Service Light: Won't Turn Off? Quote

Channel 02 must be reset first, both for LL and for non-LL vehicles . For vehicles that support LL, the LL capabilities must then be added.

smith2 wrote:
Sorry Bertil,

You got to me first.
My answer does not refer to yours.


That was already clear.



marco wrote:
Hi Bertil,

Thank you for the information! I will continue to monitor the FIS. Can you add this point to the instructions? I think it would be very helpful.


Was soll ich ergänzen? Is this it?

"After the LL inspection, the minimum interval is initially displayed, and it gradually increases over time to reach the target LL value. This process depends on the driving profile."

However, this only applies to AUDI vehicles, as it is not possible to query the remaining mileage for VW vehicles.
Gruß Bertil

Skoda 5E5 CZDA + Mini R50 W10 + VW ID.3 + Fiat Ducato 250 + 161 DX

*** Technische Anfragen per PN werden von mir nicht beantwortet! ***


Translated on 29-10-2026, 10:25.
Back to top Profile PM
Marco
Guest




 


Free account, no CAN development support

Post26-04-2004, 11:47    Subject: Reset Service Light: Won't Turn Off? Quote



Was soll ich ergänzen? Is this it?

'After the LL inspection, the minimum interval is initially displayed, and it gradually increases over time to reach the target LL value. This process depends on the driving profile.'

This only applies to AUDI, as it is not possible to query the remaining mileage for VW vehicles.

Yes, that's exactly the point I'm making.


Translated on 29-10-2026, 10:27.
Back to top
Bertil
Profi-Schrauber
Profi-Schrauber


Joined: 04/15/2002
Posts: 5628
Karma: +108 / -0   Thank you, like it!


Premium Support

Post26-04-2004, 14:15    Subject: Reset Service Light: Won't Turn Off? Quote

Marco wrote:
Yes, that's exactly the point I'm making.


Done!
Gruß Bertil

Skoda 5E5 CZDA + Mini R50 W10 + VW ID.3 + Fiat Ducato 250 + 161 DX

*** Technische Anfragen per PN werden von mir nicht beantwortet! ***


Translated on 29-10-2026, 10:27.
Back to top Profile PM
Wolfgang
Guest




 


Free account, no CAN development support

Post26-04-2004, 18:44    Subject: Reset Service Light: Won't Turn Off? Quote

However, this only applies to AUDI, as it is not possible to query the remaining kilometers for VW vehicles.
And I was just about to ask icon_biggrin.gif.


Translated on 29-10-2026, 10:28.
Back to top
Marco
Guest




 


Free account, no CAN development support

Post06-05-2004, 10:14    Subject: Reset Service Light: Won't Turn Off? Quote

Hello fellow enthusiasts,

To wrap up the topic, after 593 km, there seem to be some initial calculations. The total mileage displayed on the car's computer is now 29,800 km. Let's see what else comes up.


Translated on 29-10-2026, 10:28.
Back to top
Bertil
Profi-Schrauber
Profi-Schrauber


Joined: 04/15/2002
Posts: 5628
Karma: +108 / -0   Thank you, like it!


Premium Support

Post06-05-2004, 10:24    Subject: Reset Service Light: Won't Turn Off? Quote

Hi Marco,

Thank you for the information.
Gruß Bertil

Skoda 5E5 CZDA + Mini R50 W10 + VW ID.3 + Fiat Ducato 250 + 161 DX

*** Technische Anfragen per PN werden von mir nicht beantwortet! ***


Translated on 29-10-2026, 10:29.
Back to top Profile PM
hy-fye1



Joined: 06/25/2007
Posts: 1
Karma: +0 / -0   Thank you, like it!


Free account, no CAN development support

Post25-06-2007, 18:10    Subject: Reset Service Light: Not Working? (Fix Now!) Quote

Hello everyone,

I'm new here and happy to have found you, as I'm having a big problem with resetting the longlife service indicator.

The following problem:

1. In VAG-Com, I select control unit 17.
2. Now, I'm going to click on "Customize."
3. Now I enter channel number 02 and click "read".
4. I am now entering 00 as the new value.
5. Now, I enter channel number 45 and click "read".
6. If I click on "test" now, I get the error message "Error in the 'Test Value' field."

What am I doing wrong? I'm on the verge of a nervous breakdown.
I hope you can help me.


Okay, I have an A4 Avant Quattro 3.0, model 8E, manufactured in December 2002, and I'm using VAG-Com version 3.03.


Best regards,
Markus.


Translated on 29-10-2026, 10:30.
Back to top Profile PM
Ross-Tech-Support
Profi-Schrauber
Profi-Schrauber


Joined: 05/30/2005
Posts: 646
Karma: +8 / -0   Thank you, like it!


Support

Post27-06-2007, 0:00    Subject: Resetting Service Indicator: Not Working! Quote

Are you writing an email...?


...in the email, please include your name, address, and license number. Then we'll see what happens, or not, if we don't receive an email or if you can't provide a valid license number – which is something we can assume based on the error message, because with legitimate VAG-COM versions, this usually works without any problems.

hy-fye1 wrote:
What am I doing wrong? I'm on the verge of a nervous breakdown.


icon_twisted.gif


Translated on 29-10-2026, 10:32.
Back to top Profile PM
a4b82.0tdi



Joined: 10/23/2017
Posts: 15
Karma: +1 / -0   Thank you, like it!


Premium Support

Post23-10-2017, 21:19    Subject: Reset Service Light: Won't Turn Off? Quote

Hello, I'm new here.

and I am also unable to set channel 2 in control unit 17 from module 1 to 0. I can specify the value or indicate it with up and down arrows, but I cannot execute the change. I receive a message to do it in the main menu. Even when I select and execute the LL-Service (…Rest of the World/Diesel…), the message "Service due!" remains when the engine is turned on and off.
I updated my VDCS software today.
I have tried the suggested solution – resetting Channel 2 to 0 first, and then running the LL service – multiple times, both in that order and in reverse order.
How can I get rid of this "Service due!" message?

Thank you for any help.


Translated on 29-10-2026, 10:34.
Back to top Profile PM
New Topic Reply 🔗 ⭐ 🖨 Dieselschrauber - Index » On-Board Diagnostics (OBD)
Go to page: 1, 2  Next
Similar articles and topics
Topic Forum
No new posts Audi Longlife Service: Your Best Choice Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
No new posts Some information about the longlife service Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
No new posts VAG Longlife Oil Standards Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
No new posts Reset Service Light (Cars '98+) On-Board Diagnostics (OBD)
No new posts Service zurücksetzen Audi A3 8p On-Board Diagnostics (OBD)
No new posts Skoda Octavia 1Z: Reset Service Light On-Board Diagnostics (OBD)
No new posts Long Life Service: Your Car's Extended Warranty On-Board Diagnostics (OBD)
Jump to:  
You cannot post new topics in this forum.