Assign label file to Audi S3 A B T

Hello everyone,

Today, I tried to read the measurement data from the engine control unit (ECU) of an S3 8P manufactured in 2008, but I found that there was no label file available. I then searched on Google and discovered that this might be due to the A B T control unit, which has "A B T" in its part number. I also read something about a redirect file.

"Could someone possibly explain how to find and open the actual label file for the engine (CDLA 2.0)? Or even how to use the redirect file method?"

If I had a list showing which block contains each value, that would be enough for now. The vehicle is experiencing misfires on cylinder 3.

VIN: WAUZZZ8P99A076808

Best regards from Switzerland.

Hi,

Yes, unfortunately, the engine control unit then provides a modified VAG part number.

Please post an Autoscan result. I would like to try copying the correct label file and then modifying it with the part number from the Autoscan.
It's possible that this could conflict with the redirection.

Best regards, Rainer.

Unfortunately, I don't have a scan available right now; the vehicle will be brought in for diagnosis next week.

According to AKTE, the part number is: 8P0 907 115 AP.

I couldn't find that label file under the "LABELS" directory.

What could be the reason for that?

Best regards, Mischa.

Hello,

"Wildcards" are used in the label search.

Ross-Tech wrote:

Address 01: Engine (CDL) Labels: 06F-907-115-CDL.clb Part Number (Software): 8P0 907 115 AP Hardware: 8P0 907 115 B Component: 2.0l R4/4V TFSI 0010

The label file is 06F-907-115-CDL.clb .

Best regards, Rainer.

Thank you very much, Rainer.

Can I view this as plain text somehow, or simply rename the file to the "A B T number"?

Hello,

The .clb file is encrypted. Use VCDS to access the engine control unit and rename the copied file to match the part number shown by A B T. Replace spaces with hyphens. Make sure to keep the .clb extension.

Best regards, Rainer.

I just wanted to let you know that the solution with copying and renaming worked perfectly.

Regards,
Mischa.

Thank you for the feedback!