Error codes and their possible causes for Teves Mark 20 IE (Solution)

Error codes and their possible causes for Teves Mark 20 IE




00283
Speed sensor front left G47 or Speed sensor front left G47 Open/Short circuit to positive.

Rotor is dirty or damaged.
Wheel bearing play is excessive.
Speed sensor G47 not properly installed.
Speed sensor G47 is defective.
Short circuit to ground.
Incorrect ECU version.
Wiring interruption, short circuit to positive in the wiring between the speed sensor G47 and the control unit J104.



00285
Speed sensor front right G45 or Speed sensor front right G45 Open circuit/short circuit to positive voltage

Rotor is dirty or damaged.
Wheel bearing play is excessive.
Speed sensor G45 not properly installed.
Speed sensor G45 is defective.
Short circuit to ground.
Incorrect ECU version.
Wiring interruption, short circuit to positive in the wiring between the speed sensor G45 and control unit J104.



00287
Rear Right Tachometer G44 or Rear Right Tachometer G44 Open Circuit/Short to Ground

Rotor is dirty or damaged.
Wheel bearing play is excessive.
Speed sensor G44 not properly installed.
Speed sensor G44 is defective.
Short circuit to ground.
Incorrect ECU version.
Wiring fault, short circuit to positive in the wiring between the speed sensor G44 and the control unit J104.



00290
Rear Left Speed Sensor G46 or Rear Left Speed Sensor G46 Open/Short to Power

Rotor is dirty or damaged.
Wheel bearing play is excessive.
Speed sensor G46 not properly installed.
Speed sensor G46 is defective.
Short circuit to ground.
Incorrect ECU version.
Wiring interruption, short circuit to positive in the wiring between speed sensor G46 and control unit J104.



00538
Reference Voltage

Interruption, Short circuit after plus or ground in the lines:
{INPUT_DEVICE} for {ROTATION_SPEED} G202
Sensor for Lateral Acceleration G200
Donor 1 for Brake Pressure G201
Donor 2 for Brake Pressure G214



00668
Board voltage, terminal 30, signal outside of tolerance

Interruption, Short circuit to positive or negative.



00778
Sender for Steering Angle G85: No communication, implausible signal, mechanical failure

Interruption or loose connection in the data lines between the sender for steering angle G85 and the control unit J104
Gear for steering angle -G85- defective
Sender for Steering Angle -G85- sends no or incorrect setting values
The mounting position for the sensor for steering angle G85 is incorrect.
Vehicle geometry is not optimal.
The steering wheel was removed and subsequently, no zero-tolerance adjustment was performed.
Unacceptable vibrations in the steering system due to wear and tear.



00810
Provide 1/2 for brake pressure, implausible signal

Brake pressure supply line to actuator 1 or 2 interrupted.
Short circuit the signal line to sensor 1 for brake pressure G201 or sensor 2 for brake pressure -G214
Faulty: Sender 1 for Brake Pressure G201 or Sender 2 for Brake Pressure G214
A hydraulic brake circuit has failed.



00812
Switch for magnetic field Brake Pressure - F84

Interruption, Short circuit after plus or ground in the lines
Brake booster malfunction


00813
Faulty brake pressure sensor G214 in the circuit

Interruption, Short circuit after plus or ground in the lines:
Faulty G214 brake pressure sensor



00814
Magnet coil for brake pressure N247

Interruption, Short circuit after plus or
Mass in the pipes:
Brake booster malfunction
Faulty power stage in control unit J104
ABS control unit J104 is faulty.



01044
ECU incorrectly coded

The control unit -J104 is coded for a vehicle with a manual transmission. The vehicle is equipped with an automatic transmission.



01130
ABS Operation: Implausible Signal

Electrical interference caused by external sources (high-frequency radiation)
Interruption, Short circuit after plus or ground in the lines
ABS control unit J104 is faulty.



01276
Hydraulic pump ABS V64 signal outside tolerance

Interruption, Short circuit after the plus or in the lines
Internal Connection Hydraulic Pump V64 to Control Unit
Hydraulic pump V64 faulty
ABS control unit J104 is faulty.
Hydraulic pump V64 faulty



01279
Gear for Longitudinal Acceleration G251 electric. Fault in the electrical circuit

Interruption, Short circuit after plus or ground in the lines
The mounting position of the G251 longitudinal acceleration sensor is incorrect.
Accelerator for Longitudinal Acceleration G251 defective



01423
Sensor for Lateral Acceleration G200, electronic. Fault in the electrical circuit

Interruption, Short circuit after plus or ground in the lines
Sensor for Lateral Acceleration G200 is defective
The mounting position of the G200 accelerometer sensor is not correct.



01434
Relay for brake light suppression. ESPJ508 electrical. Fault in the electrical circuit

Interruption, Short circuit after plus or ground in the lines
Relay for brake light suppression J508 is defective



01435
Donor 1 for Brake Pressure G201 electric. Fault in the electrical circuit

Interruption, Short circuit after plus or ground in the lines:
Donor 1 for Brake Pressure G201 - Defective



01542


Interruption, Short circuit after plus or ground in the lines
The mounting position of the encoder G202 is not correct.
Encoder for speed G202 defective



65535
Control unit malfunction

Engine Control Unit J104 is faulty.