Find the AAT, duty cycle, E-begin in the individual measurements?

Hello,
AAT with first class honors. Version only displays measurement block 00.

That means, for example, in 4-4 mode, I can't see the duty cycle for the start of injection.

Can the duty cycle be seen in the 'individual measurement value,' and if so, what value is it?
What value would 100% represent, and what value would 0% represent?

Thank you for the answers.

Regards,

Frank.

Look here:
[url][/url]http://www.dieselschrauber.de/Solldaten_5_Zylinder_VE.html{MARKER}

Of course, I know this data page!
but
'AAT with first class degree.' 'The display only shows measurement block 00.'

I think I might be able to find the sampling rate under the individual measurement values.

I have one of the first 1Z models, so it's the same situation as you have.

Can you see the duty cycle anywhere? I can't!

You can connect a voltmeter, and then you'll see them!

Looking at the individual data points, you can see a large number of channels. These channels are not documented, but they likely represent data flows within the system. Ideally, there should also be information about the duty cycles available there.