VCDS and OBD diagnostic device in the On-Board Diagnostics Shop
Wrenchers and tuners: diesel, petrol, OBD/VCDS. Repair, maintenance, diagnostics - help that's proven on the car.

2.5 TDI VP44: How to Remove PSG Cover

 
New Topic Reply 🔗 ⭐ 🖨 Dieselschrauber - Index » Diesel Engine Technology
Author Message
Ruffy
Blaumann
Blaumann


Joined: 12/05/2009
Posts: 109
Karma: +2 / -1   Thank you, like it!
Location: Aachen

Free account, no CAN development support

Post13-05-2010, 10:48    Subject: 2.5 TDI VP44: How to Remove PSG Cover Quote

Good morning!

I hope that, despite Father's Day, a few people will be able to help me icon_wink.gif.

Currently, I'm having a problem where my Passat TDI (engine code: AKN) is not running, and the cause is still unknown. I would like to inspect the PSG (Powertrain Control Module) from the inside to see if the well-known defect is present and if the bonding connection has come loose.

However, I'm a little apprehensive about removing the lid. From what I've read, you should cut around the edge once (like you would with a stuck lid) and then screw in 2 screws into the holes.

So far, so good. I've managed to screw in two screws. However, when I pull on it, the lid unfortunately doesn't come off; instead, the screws come loose.
Or should the screws be tightened so far that the device lifts off on its own? At first glance, this seems illogical because the holes at the bottom are closed.

icon_question.gif So, the question is: What's the best way to do it?

Thank you in advance, everyone!


Best regards, Marcus.


Translated on 30-10-2026, 7:29.
Back to top Profile PM
christians
Profi-Schrauber
Profi-Schrauber


Joined: 09/05/2002
Posts: 2105
Karma: +17 / -0   Thank you, like it!
Location: Sauerland

Premium Support

Post13-05-2010, 22:24    Subject: 2.5 TDI VP44: How to Remove PSG Cover Quote

At the time, I just somehow managed to overcome it.
Gruß Christian
A6 BPP, Ex-A6 AKN (Gurke), Ex-Audi100 92 AAT (5Zyl.)


Translated on 30-10-2026, 7:30.
Back to top Profile PM
Ruffy
Blaumann
Blaumann


Joined: 12/05/2009
Posts: 109
Karma: +2 / -1   Thank you, like it!
Location: Aachen

Free account, no CAN development support

Post14-05-2010, 0:49    Subject: 2.5 TDI VP44: How to Remove PSG Cover Quote

Thank you for the response!

"Did you use a screwdriver, or something else? Do you remember which spots were the easiest to work with?"


Best regards, Marcus.


Translated on 30-10-2026, 7:30.
Back to top Profile PM
slow-moe
Schrauber
Schrauber


Joined: 12/25/2009
Posts: 105
Karma: +6 / -0   Thank you, like it!


Support

Post14-05-2010, 6:57    Subject: 2.5 TDI VP44: How to Remove PSG Cover Quote

Using a thin knife or razor blade, carefully cut all the way around, and then, starting at one corner, gently pry it open.


Translated on 30-10-2026, 7:31.
Back to top Profile PM
vwSchrauber
Profi-Schrauber
Profi-Schrauber


Joined: 09/18/2008
Posts: 1262
Karma: +43 / -0   Thank you, like it!


Support

Post14-05-2010, 9:08    Subject: 2.5 TDI VP44: How to Remove PSG Cover Quote

I did it that way too, but the VP44 was on an Opel DTI.
Using a heat gun to warm it up can also be quite helpful.
selber schrauben - statt Werkstattpfusch


Translated on 30-10-2026, 7:31.
Back to top Profile PM
New Topic Reply 🔗 ⭐ 🖨 Dieselschrauber - Index » Diesel Engine Technology
Similar articles and topics
Topic Forum
No new posts Bosch VP44 pump control unit repair Troubleshooting & Guides
No new posts Starting problems and glow plug system issues in TDI engi... Technical Articles
No new posts VE Injection Pump Data: 6-Cylinder Engine Performance (VP44) Technical Data
No new posts Audi 2.5 TDI VP44: Excessive Smoke? Dieselschrauber Bar
No new posts Airbag Replacement: Cost & How-To Guide Transmission, Chassis, Body & Interior
No new posts Bosch Part: Gasket & Screw for Quantity Meter Cover Diesel Engine Technology
No new posts VP44 Mystery: Unveiling the Secrets Diesel Engine Technology
Jump to:  
You cannot post new topics in this forum.