| Author |
Message |
david7x64
Joined: 10/27/2013 Posts: 5 Karma: +0 / -0 Location: Willich
Free account, no CAN development support
|
11-05-2020, 19:20 Subject: CBBB Motor in Tiguan, no compression on cylinders 1 and 2. |
Quote |
|
Hello, I'm experiencing the following problem with a Tiguan 1 with the 170hp CBBB engine:
The engine is not taking fuel well and has less power at low speeds. Jerks severely.
The injectors would be replaced and reprogrammed after a complete overhaul.
The engine initially ran better, but then only ran very poorly. We then performed a compression test. Result: Cylinder 1 and 2: No! (0) Compression.
What could it be? The car needs to go to the workshop next week. Does anyone have an idea?
Best regards, David |
|
| Back to top |
Profile PM |
 |
Held467 Blaumann

Joined: 09/20/2006 Posts: 479 Karma: +5 / -0
Premium Support
|
11-05-2020, 20:29 Subject: CBBB Motor in Tiguan, no compression on cylinders 1 and 2. |
Quote |
|
Hi
It's likely that the head gasket has blown.
Best regards. |
|
| Back to top |
Profile PM |
 |
dieselschrauber Administrator


Joined: 04/12/2002 Posts: 17991 Karma: +781 / -0 Location: St.Gallen 2018 Volkswagen T6 
|
11-05-2020, 21:46 Subject: CBBB Motor in Tiguan, no compression on cylinders 1 and 2. |
Quote |
|
Hello,
Without compression on individual cylinders, the only solution is to remove the head. The injectors and spark plugs should hopefully be installed correctly and be airtight, which is easy to see.
Best regards, Rainer Dipl.-Ing. (FH) Rainer Kaufmann - dieselschrauber VCDS Shop |
|
| Back to top |
Profile PM WWW Garage |
 |
aquablader
Joined: 11/30/2011 Posts: 8 Karma: +0 / -0
Premium Support
|
03-08-2021, 15:58 Subject: Curiosity |
Quote |
|
And, what was the ultimate reason, then? I'm facing a similar situation: the first two cylinders have no compression, the cylinder head is removed, the valves appear to be okay, and the piston crowns appear to be okay.
VG Ingo |
|
| Back to top |
Profile PM |
 |
david7x64
Joined: 10/27/2013 Posts: 5 Karma: +0 / -0 Location: Willich
Free account, no CAN development support
|
03-08-2021, 16:07 Subject: CBBB Motor in Tiguan, no compression on cylinders 1 and 2. |
Quote |
|
Hi, the headpiece was broken. Burned through between the cylinders.
Most likely caused by the poor injectors. |
|
| Back to top |
Profile PM |
 |
aquablader
Joined: 11/30/2011 Posts: 8 Karma: +0 / -0
Premium Support
|
03-08-2021, 16:12 Subject: Thank you. |
Quote |
|
Thank you for the response.
The poem was okay here... |
|
| Back to top |
Profile PM |
 |
matthiasTDI96 Profi-Schrauber

Joined: 02/27/2003 Posts: 5886 Karma: +251 / -0
Premium Support
|
06-08-2021, 8:16 Subject: CBBB Motor in Tiguan, no compression on cylinders 1 and 2. |
Quote |
|
Then the device was faulty or it was used incorrectly… |
|
| Back to top |
Profile PM |
 |
aquablader
Joined: 11/30/2011 Posts: 8 Karma: +0 / -0
Premium Support
|
06-08-2021, 9:29 Subject: CBBB Motor in Tiguan, no compression on cylinders 1 and 2. |
Quote |
|
What are you trying to tell me? |
|
| Back to top |
Profile PM |
 |
matthiasTDI96 Profi-Schrauber

Joined: 02/27/2003 Posts: 5886 Karma: +251 / -0
Premium Support
Herbert likes this. |
06-08-2021, 15:58 Subject: CBBB Motor in Tiguan, no compression on cylinders 1 and 2. |
Quote |
|
If the light bulbs are installed and sealed, and the valves are closed and sealed. If the cylinder head gasket and the cylinder head itself are undamaged, the piston is in place and moving, then there is nothing left but a measurement error, or? |
|
| Back to top |
Profile PM |
 |
aquablader
Joined: 11/30/2011 Posts: 8 Karma: +0 / -0
Premium Support
|
06-08-2021, 16:02 Subject: CBBB Motor in Tiguan, no compression on cylinders 1 and 2. |
Quote |
|
Who says that the pistons are in good condition? There were, in fact, two rings broken.
However, at the time the post was created, I didn't know this and therefore inquired further. |
|
| Back to top |
Profile PM |
 |
david7x64
Joined: 10/27/2013 Posts: 5 Karma: +0 / -0 Location: Willich
Free account, no CAN development support
|
06-08-2021, 17:32 Subject: CBBB Motor in Tiguan, no compression on cylinders 1 and 2. |
Quote |
|
If the light bulbs are installed, you cannot measure compression... |
|
| Back to top |
Profile PM |
 |
matthiasTDI96 Profi-Schrauber

Joined: 02/27/2003 Posts: 5886 Karma: +251 / -0
Premium Support
dieselschrauber likes this. |
07-08-2021, 7:09 Subject: CBBB Motor in Tiguan, no compression on cylinders 1 and 2. |
Quote |
|
Okay, as of August 3rd, nothing had been written about it yet. Then the cause has been found.
Of course, it is correct that the light bulbs are removed for measurement purposes. Then I remove the light bulb and say injector.
But it's great that it's been resolved. |
|
| Back to top |
Profile PM |
 |