Hello,
I want to replace the pressure sensor on my Polo 6R, 1.6 TDI, CAYB, from 2011, due to an electronic fault. According to the repair manual, I should use the "guided troubleshooting" to correctly adjust the lever. However, I don't have a VAS (only VCDS), so this is not possible. My control unit also does not support the "data block" function, so I cannot access block 120. Does anyone have any ideas on how I can correctly adjust the pressure sensor or the control lever? I only found the measurement "Turbocharger High-Pressure: Actual Raw Voltage" in VCDS, which shows a value of 4.70 V when the control lever is completely retracted and 1.36 V when the control lever is completely extended.
Last edited on 04-02-2022, 15:40, edited 1 time in total.
|
Bookmarks
Links
Garage
FAQ, Legal Notice & Privacy
RSS Feed
Register
Login
