Motorfragen zum ACV, im T4 (GELÖST) | Posts 16+

Autoservice wrote:

Have you ever stripped a screw before? Given the length, one might think that a rotating rod is being used.

Hi!
No, I've never refused a contract extension before.
"But the tool here is 3/4", made by Facom and Gedore, and it was also at its breaking point."
I marked the screw head with a colored dot and then turned it until I reached 180 degrees.
That really cost a lot of money.
but I'd say it's better than any other dodgy repair shop.
It's just tightened with a 1/2" wrench until it's snug, and that's good enough.

I'm actually quite relieved that someone wrote in this forum and told me that the screw needs to be tightened so brutally.
Otherwise, I might have just mumbled it.

Hi.

The construction is already okay!

We were two people, and we had also extended the lifting platform. The car was raised to a height of 2.2 meters on the platform – I was already worried that the car would fall off.
Ultimately, it works out - I was even a little bit happy about .

Great – another 5-cylinder engine saved!

Best regards,