Passat 3C Problem mit DSP / Radio | Posts 32+

11-03-2012, 13:32 Subject:

Yes, but the 10.77 reading from the multimeter is different from the 11.858 reading shown in VCDS.
I'll leave it plugged in overnight; the battery is only 2 months old!

What do you think about the rest?

- Disconnect the old cable (T40/17) at both ends: at the top connector and at the amplifier's connector.
- Error entries in the board network?

Thank you.

11-03-2012, 13:57 Subject:

I would either disconnect the old cable or, as I wrote at 10:42, repair it:

guste100 wrote:

My tip for a cable break: The distribution where one cable is split into three pins is likely to be damaged. This is a common source of errors. EDIT: So, free the cable bundle from its outer sheath near the amplifier and look for the splice.

The error in the BnSTG system occurred on March 6th and is likely due to the removal of a safety enclosure (SB), which resulted in the loss of power supply to the BnSTG.