Replacing control arm bushings on an Audi 80 TDI

Hello!

"The ball joints on the control arms of my Audi 80 are worn out. I would appreciate any tips on how to remove them without a press (using a socket?). For example, with my old Passat from 1985, I smashed the rear axle bushings radially with a chisel until they popped out (I'm not sure if that works for control arm ball joints!)."

Thank you in advance!!!!

Hi,

How about using a thick threaded rod, two nuts, and a pipe for support?
Insert the threaded rod into the tube, and then place the tube onto the control arm, passing the threaded rod through the bushing that needs to be removed.
The pipe must have a larger inner diameter than the sleeve being removed. Alternatively, two angle irons can be used for support.
Then, add two suitable nuts or similar items onto the threaded rod, place the nut on top, and tighten .
-> It costs almost nothing, and with an M12, you can pull quite a bit.

Best regards, Rainer.

That sounds great! Thank you very much.