Short Circuit Error Code Explained

The error codes repeatedly provide the names.

"Interruption/Short circuit after positive voltage."

or

"Short circuit to ground"

Sure, here is the translation of the text from German to English:

"aus."

Can someone briefly explain what's specifically involved here, or what the difference is between the two?

Hello,

It depends on the specific circuit configuration, so a circuit diagram is very helpful in each case to determine what is going wrong.

In the first case, the potential at the corresponding measurement point is +12V or there is no signal; in the latter case, it is at ground potential.

Open circuit/Short circuit to positive: Often caused by corroded or broken wires, loose connectors, or damaged insulation that creates a short circuit to the positive terminal.

Short circuit to ground: This is often caused by damaged cable insulation that is rubbing against the vehicle's body (ground, 0V), or by a faulty sensor that has an internal short circuit.


Best regards, Rainer.