VCDS and OBD diagnostic device in the On-Board Diagnostics Shop
Diesel, Engine Technology and Vehicle Technology. Repair, Maintenance and Diagnostics (OBD).

Cables vs. Coolant Hoses: Which is Best?

 
New Topic Reply 🔗 ⭐ 🖨 Dieselschrauber - Index » Diesel Engine Technology
Author Message
andre
Guest




 


Free account, no CAN development support

Post08-01-2005, 13:53    Subject: Cables vs. Coolant Hoses: Which is Best? Quote

Hello,

I was wondering if there could be any problems if cables (electrical wires) are in contact with refrigerator hoses? The hoses only get a maximum of 100 degrees Celsius hot. Could this cause any damage to the cables over time?

THX
Andre.


Translated on 19-10-2026, 19:33.
Back to top
gwg
Guest




 


Free account, no CAN development support

Post08-01-2005, 14:03    Subject: Cables vs. Coolant Hoses: Which is Best? Quote

Hello,
As long as the cables aren't rubbing against the radiator hose, everything is fine.
Best regards,
Günther.


Translated on 19-10-2026, 19:34.
Back to top
andre
Guest




 


Free account, no CAN development support

Post09-01-2005, 2:57    Subject: Cables vs. Coolant Hoses: Which is Best? Quote

'No scrubbing was needed, I just had to attach one cable to a cooler with a zip tie so it wouldn't hit my engine heater.'


Translated on 19-10-2026, 19:34.
Back to top
New Topic Reply 🔗 ⭐ 🖨 Dieselschrauber - Index » Diesel Engine Technology
Similar articles and topics
Topic Forum
No new posts CAN Interface RKS+CAN & SUB-D9 Cable On-Board Diagnostics (OBD)
No new posts OBD2 Cable: Connect & Diagnose Your Car Diesel Engine Technology
No new posts Cable Tuning: Optimize Your Car's Performance Diesel Engine Technology
No new posts Cable differences Transmission, Chassis, Body & Interior
Jump to:  
You cannot post new topics in this forum.