VCDS and OBD diagnostic device in the On-Board Diagnostics Shop
Diesel, Engine Technology and Vehicle Technology. Repair, Maintenance and Diagnostics (OBD).

Troubleshooting after error code reading

 
New Topic Reply 🔗 ⭐ 🖨 Dieselschrauber - Index » On-Board Diagnostics (OBD)
Author Message
Mike²



Joined: 12/27/2006
Posts: 1
Karma: +0 / -0   Thank you, like it!


Free account, no CAN development support

Post27-12-2006, 23:36    Subject: Troubleshooting after error code reading Quote

After experiencing problems with the orange warning light on my Polo (9N, 1.9L, manufactured in 2004) – the same light that comes on when the ESP is deactivated –
I performed a diagnostic scan on a friend's car.
Even though it can't perform a fault-guided diagnosis, we still aren't making any progress.

Here's the translation:

"The following are the errors or error codes:"

1.)
01 - Motor electronics.
038906019LA
1.9L R4 EDC G000SG 5405

Error:
17911
Belastungssignal von Generatorkl. DF
sporadically

2.)
03 - Brake electronics.
6Q0907379Q
ESP 5.7 font, H03.

Error:
18265
Last signal.
sporadically

3.)
08 - Climate control/heating electronics.
6Q0907044B
CLIMAtronic PQ24

Error:
00710
Defrost flap actuator - V107.
sporadically

Error:
01273
Fresh air blower - Version 2.
sporadically

I assume that all four errors originate from the same source.
Can someone provide me with more details about this information?
Or do you require any further information?

Thank you in advance.
Mike squared.


Translated on 23-09-2026, 20:49.
Back to top Profile PM
Bertil
Profi-Schrauber
Profi-Schrauber


Joined: 04/15/2002
Posts: 5628
Karma: +108 / -0   Thank you, like it!


Premium Support

Post28-12-2006, 1:16    Subject: Troubleshooting after error reading Quote

Mike² wrote:
...
Or do you require any further information?
...


The MKB wouldn't be bad...

but the search function excludes the thread https://community.dieselschrauber.org/en/viewtopic.php?t=1793&highlight=17911.

The error code 17911 is also mentioned there.

Error code: 17911.
Load signal from generator terminal DF: implausible signal.

Possible causes:
Generator failure.
Voltage regulator faulty.
Power outage.

Possible effects:
Auxiliary heating not working.


So, if your on-board voltage is incorrect due to a defect (see above), then the other errors are likely secondary issues resulting from that initial problem.
Gruß Bertil

Skoda 5E5 CZDA + Mini R50 W10 + VW ID.3 + Fiat Ducato 250 + 161 DX

*** Technische Anfragen per PN werden von mir nicht beantwortet! ***


Translated on 23-09-2026, 20:52.
Back to top Profile PM
New Topic Reply 🔗 ⭐ 🖨 Dieselschrauber - Index » On-Board Diagnostics (OBD)
Similar articles and topics
Topic Forum
No new posts Audi A4 B7/8E 1.8T BFB - Shaking/Vibration after cold start Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
No new posts Document: Performance loss over time, MKB AFB, AKN, AKE, AYM Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
No new posts Document A3, Differential Failure After Mileage Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
No new posts nach reifenwechsel zieht kfz leicht nach rechts Transmission, Chassis, Body & Interior
No new posts Increased fuel consumption after MFA following AGR decomm... Diesel Engine Technology
No new posts MFA After Eco-Tuning On-Board Diagnostics (OBD)
This topic is locked, you cannot edit or reply. Regeneration nach km Diesel Engine Technology
Jump to:  
You cannot post new topics in this forum.