VCDS and OBD diagnostic device in the On-Board Diagnostics Shop
Diesel, Engine Technology and Vehicle Technology. Repair, Maintenance and Diagnostics (OBD).

Brake Light Stays On: Causes & Fixes

 
New Topic Reply 🔗 ⭐ 🖨 Dieselschrauber - Index » Diesel Engine Technology
Author Message
g1om
Guest




 


Free account, no CAN development support

Post20-01-2004, 21:33    Subject: Brake Light Stays On: Causes & Fixes Quote

hi

After putting up with issues with my Seat Ibiza AFN for quite some time, the car really let me down yesterday.
After work, I wanted to start it, but I couldn't.
After searching for a while, I finally found a broken development motor mass cable outside. It was simply broken.
It's not that bad, really.

Now, I still have a problem.

The warning light for the handbrake and/or brake fluid level is constantly illuminated.
I've also already tested both switches, and they're okay.
I have error code 00626 in the error memory, but I don't know what it means!
'The sender I received is for the coolant level, but I haven't installed it.'

Before I go to the Seat dealership and they try to charge me for something, I'd rather figure out the problem myself. However, it's very difficult to do that without a wiring diagram.

I would have liked to hear your opinions on what might have been smoked.

Everything was still working perfectly fine before the mass cable was connected this morning.

Sure, here's the translation:

'Thanks in advance.'


Translated on 07-10-2026, 3:37.
Back to top
g1om
Guest




 


Free account, no CAN development support

Post21-01-2004, 19:15    Subject: Brake Light Stays On: Causes & Fixes Quote

Hey, does anyone have even the smallest tip they can offer?

Could it be related to the wiring harness or the instrument cluster?
Could you possibly provide me with a circuit diagram?


Translated on 07-10-2026, 3:39.
Back to top
ulf
Profi-Schrauber
Profi-Schrauber


Joined: 04/13/2002
Posts: 11058
Karma: +18 / -0   Thank you, like it!
Location: Saarland
2023 MG ZS
Premium Support

Post21-01-2004, 19:26    Subject: Brake Light Stays On: Causes & Fixes Quote

g1om wrote:

I have error code 00626 in the error memory, but I don't know what it means!
the sender
that the sender is writing about is for the coolant level, and I haven't installed it!
VAGCOM-Fachartikel wrote:

Hi,

"
"I'm getting inconsistent text when I read the STGe error memory!"
-> Reflect on yourself and make sure you have the proper authorization for your VAG-COM version! }

Regarding Seat wiring diagrams, I can't help you with that... It's possible that your instrument panel is receiving incorrect voltage due to the faulty ground cable, has been partially damaged, and that's why the brake light is on (pure speculation).
Gruß Ulf
_________

MG4 Electric


Translated on 07-10-2026, 3:40.
Back to top Profile PM Garage
Martin R
Guest




 


Free account, no CAN development support

Post24-01-2004, 12:51    Subject: Brake Light Stays On: Causes & Fixes Quote

Your wiring harness might be faulty.

The faulty ground cable likely caused the starter to draw ground through your switches/controls.

Cases like these are not uncommon.


Translated on 07-10-2026, 3:41.
Back to top
DocSnydor
Guest




 


Free account, no CAN development support

Post26-01-2004, 12:50    Subject: Brake Light Stays On: Causes & Fixes Quote

Sorry for the overly complicated question: icon_rolleyes.gif

Is the brake fluid level correct? You mentioned that you don't have such a sensor, but I couldn't tell if you actually checked it...

I actually had a similar problem before, where the light wouldn't turn off. In my case, the fluid level was also incorrect, and I was very surprised that my 1994 Passat could display something like that.


Translated on 07-10-2026, 3:42.
Back to top
g1om
Guest




 


Free account, no CAN development support

Post02-02-2004, 18:15    Subject: Brake Light Stays On: Causes & Fixes Quote

Yes, I already checked it and it's all good.

I had the car at the Seat dealership last Friday, and they actually quoted me 2,5 [presumably a price or amount].
Working hours inflated!
This afternoon, the friendly lady called me to say the car was ready, but unfortunately, they couldn't find the problem.

What now???

Did they really want me to pay for everything? *g*
I have given all of this to my lawyer.
They won't see a single penny from me as long as the lights are on!
That's definitely the last car from the Volkswagen group!
Next time, let's do something worthwhile.

Okay, I went ahead and tried to troubleshoot the problem myself.
I had a spare central electrical box lying around, so I just plugged it in.
Besides, it's typical VW stuff, with all the usual installation hassles.
Unfortunately, it didn't help.

Do you have any other ideas about what might be causing this?


Translated on 07-10-2026, 3:44.
Back to top
New Topic Reply 🔗 ⭐ 🖨 Dieselschrauber - Index » Diesel Engine Technology
Similar articles and topics
Topic Forum
This topic is locked, you cannot edit or reply. Oil stain under the car - transmission fluid or brake fluid? General Tips
No new posts DPF not regenerating Troubleshooting & Guides
No new posts CR-TDI V6 2.7L: Adjustment Channels Not Working Faults & Documentation (Audi, VW, Seat/Cupra, Skoda)
No new posts Service reminder does not expire after WIV reset. On-Board Diagnostics (OBD)
No new posts Brake Assist Error: ESP Turns Off Repeatedly On-Board Diagnostics (OBD)
No new posts Hydraulic Jack: Manual Operation & Use Diesel Engine Technology
No new posts Manual Lumbar Support Adjustment: How To? Diesel Engine Technology
Jump to:  
You cannot post new topics in this forum.