VCDS and OBD diagnostic device in the On-Board Diagnostics Shop
Diesel, Engine Technology and Vehicle Technology. Repair, Maintenance and Diagnostics (OBD).

Wheel Bearing Replacement: Cost & Prices

 
New Topic Reply 🔗 ⭐ 🖨 Dieselschrauber - Index » Transmission, Chassis, Body & Interior
Author Message
RaZoR
Guest




 


Free account, no CAN development support

Post06-06-2004, 17:32    Subject: Wheel Bearing Replacement: Cost & Prices Quote

Hello everyone!

My front wheel bearing (driver's side) is starting to fail (now at 94,000 km / Golf IV AJM). It's starting to make a rolling noise.

My mechanic says it will cost approximately 300€ (one wheel bearing plus installation and removal).

Isn't that a bit overpriced?
According to the expert, 2 hours of labor are scheduled for this particular storage unit.

Can this be correct?

What are your thoughts on this?

'Thank you.'


Translated on 19-10-2026, 15:52.
Back to top
Gremlin
Guest




 


Free account, no CAN development support

Post06-06-2004, 18:27    Subject: Wheel Bearing Replacement: Cost & Prices Quote

I'll ask about it tomorrow afternoon (Monday).

'But it only takes 2 hours if all the forces of darkness come together...'

CU Gremlin.


Translated on 19-10-2026, 15:53.
Back to top
RaZoR
Guest




 


Free account, no CAN development support

Post06-06-2004, 18:32    Subject: Wheel Bearing Replacement: Cost & Prices Quote

Sure, here's the translation:

'It would be nice...'

Thank you in advance...


Translated on 19-10-2026, 15:54.
Back to top
olli
Profi-Schrauber
Profi-Schrauber


Joined: 05/24/2002
Posts: 581
Karma: +46 / -0   Thank you, like it!
Location: Berlin

Premium Support

Post06-06-2004, 19:48    Subject: Wheel Bearing Replacement: Cost & Prices Quote

Hi,
"I paid around 250 euros two years ago for two front wheel bearings on an A6, if that's helpful. However, that was at an independent garage. I would recommend replacing both wheel bearings if one is worn out, because the other one usually won't last much longer."
Just get a counteroffer from a less-than-"friendly" icon_smile.gif workshop.

Best regards from Berlin.
Olli.
A6 CANA/JME /
'95 Cinquecento als Stadtgurke ~~ 124CS0 für den Sommer...
Ex-A6 AEL


Translated on 19-10-2026, 15:54.
Back to top Profile PM
joergs
Guest




 


Free account, no CAN development support

Post06-06-2004, 22:27    Subject: Wheel Bearing Replacement: Cost & Prices Quote

'I replaced the wheel bearings myself on my old Passat 35i facelift. It took about 2-3 hours for both sides, but I had to take it to a local mechanic to have the bearings pressed in and out (one bearing was so tight that the press had a hard time). I paid a small fee for their help, and the bearings were from an auto parts store with a 150,000 km warranty. I don't remember exactly how much the bearings cost, but it wasn't much.'


Translated on 19-10-2026, 15:55.
Back to top
New Topic Reply 🔗 ⭐ 🖨 Dieselschrauber - Index » Transmission, Chassis, Body & Interior
Similar articles and topics
Topic Forum
No new posts VP Duesen Printing Costs: What You Need to Know Diesel Engine Technology
No new posts ESP - active in left turns after wheel bearing replacement Diesel Engine Technology
No new posts ZR+WAPU Switch: Cost Savings for 1-Family Homes Diesel Engine Technology
No new posts Timing Belt 1.9L PD: How Long Does It Last? Diesel Engine Technology
Jump to:  
You cannot post new topics in this forum.