Hello,
Yesterday, I tried to perform the basic setup following the instructions.
The initial setup without the engine running didn't work (it was aborted for safety reasons). So, I then performed the procedure with the engine running. There was a rattling sound in the transmission, which is normal. Finally, the output message: "Process completed."
After that, I conducted the test drive as described.
Now, let's get to the problem:
When driving in mode D, the clutch disengages when I release the accelerator. The display then no longer shows D3/D4/D7, but only "D". When I brake, the gears re-engage and remain engaged.
At level "S", everything is normal.
Does anyone have an idea? I need to travel from Berlin to Chemnitz

tomorrow.
The problem is that I can't check if the basic settings are complete because I don't have the main device. I only have a list where I can query thousands of data points by selecting them (e.g., measured values).